Reducer bend to size

What it is

A reducer bend is a round reducer where the two connections are not in one line but stand at an angle to each other.

When you need it

You need a reducer bend when you have to connect two sizes and the run also changes direction.

• A dust hose from your saw or sander that cannot go straight to your extractor and needs a bend
• A drain or ventilation pipe that changes diameter and makes an angle at the same time
• A workshop project where a hose or pipe has to go around something and the connections have to stay straight

What you choose in the configurator

You enter the diameter for each end and choose socket or spigot per end. You choose the length of each connection and the angle: 30°, 45°, 90° or an in-between angle such as 37.5°. Then you choose the material: PLA, PETG, PETG-CF or ABS.

We only say a part is suitable for pressure, drinking water, gas or heat once we have tested that ourselves.

How to measure

For a socket, measure the outside of the pipe that goes in. For a spigot, measure the inside of the opening the part goes into. Measure in millimetres and use a caliper if you have one.